If the ‘request command’ (COMMAND+? +CR (0x0D)) has came from a controller. * Refer to the following table for the contents of COMMAND and EVENT. * The form of EVENT presupposes that it is the same as that of COMMAND. The EVENT should be sent within 5 seconds after the state of the system (AVR) is changed. The result is sent, when a system is operated directly and a state changes The message sent to a controller (Touch Panel etc.) from a system (AVR) Send the COMMAND in 50ms or more intervals. The message sent to a system(AVR) from a controller(Touch Panel etc.)Ī command to a system is given from a controller. marantz and DENON AVR control protocolĪccording to the Denon AVR control protocol the following three data forms are defined: Form Consider, that you can only have one connection open to an AVR at the same time. This is to respect the timeouts and intervals defined in the marantz and DENON AVR protocol and somewhat syncronise the request COMMAND and RESPONSE play. a connection to the AVR is opened to issue one or several COMMANDS and as soon as the last RESPONSE is in, it will be closed.įurther, this package will create a fifo-buffer that cues all commands, sent to the AVR. EVENTS that get triggered by COMMANDS are omitted. This packages only supports COMMAND and RESPONSE for now. What parts of the protocol are covered by this package? You might want to install the marantz-denon-upnpdiscovery package as well, if you don't like to lookup your AVR's IP address by hand. It was written to support the homebridge-marantz-denon-telnet package. This package allows to control your marantz or Denon AVR over telnet. Npm package to control marantz and Denon AVR over good ol' telnet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |